Hurley jr bolt puller. Box 3691 Boulder, CO 80307 contact@safeclimbing.

Hurley jr bolt puller P. Most of the pullers I make are for testing bolts to destruction so have to run around the 60-80kN level (my bigger "portable" one will pull 100kN easily) but weight becomes an issue with hydraulic systems. Spin in short bursts t American Safe Climbing association. org. The ASCA is a 501(c)3 Nonprofit. 00 Only 2 available Replacement Ball Screw and Nut. Used for removing: 3/8″ wedge bolts, 3/8″ sleeve bolts, and 3/8″ split shafts Hurley Jr. This is one of the original bolt pullers designed by Geir Hundal and distributed by the Access Fund. Geir has information on his site with instructions to build your own, which can be done with minimal tools. Box 3691 Boulder, CO 80307 contact@safeclimbing. Tax ID #68-0419449. O. Bolt Puller. They use a half inch bolt rather than ball screw to generate tensile force and pull wedge or sleeve bolts. $32. cs. Please be advised that by using these plans to construct and use these tools, you are accepting all liability for any accidents or injuries that may occur. Bolt puller. Spinner tool is made from an SDS drill chuck adapter and a step-down coupling nut with an internal set screw. $87. Dec 3, 2018 · I have broken brand new 3/8" wedge bolts in test rock, but almost any of the designs are capable of that. 00 Hurley Sr. 00 Only 2 available Core Drill Adapter. $90. Thanks! Hurley Jr. Jason Haas demonstrates the use of the "Hurley Junior" tool at the Future of Fixed Anchors II Conference in Red Rocks on April 2, 2016 by removing a wedge bo Extracting a wedge bolt. Building your own bolt puller is possible, and I have instructions below for doing so. ercu qmo mjd emoes mrudt gbuabn vsykd thqw qylrdyf gpke